SR20 Forum banner

1 - 6 of 6 Posts

·
chi-town ser
Joined
·
658 Posts
Discussion Starter · #1 ·
I finally finished my homemade CAI. It can also go to WAI which I ran up till this weekend. I have my 75 shot ready also. Just need to connect a few more things and I will be spraying. I have my ACT clutch ready just need the cash for the install.

 

·
Registered
Joined
·
744 Posts
Where did you buy the piping and what size? Did you need to use a reducer for the MAF?
 

·
chi-town ser
Joined
·
658 Posts
Discussion Starter · #5 ·
piping was from JC Whitney I have 2 1/2" from TB to MAF and 3" from MAF to the air filter. I bought 2 1/2" 90 degree bend and a 3" 180 degree bend pipe--Some cheap fittings are on it now from Home Depot but am getting red silicon to dress it up better and will be sanding and painting both pipes to finish it off. This is just a rough in that I just finished. Total spent was prolly about $40 or so. I will post more pics once painted.
 

·
no..its not my daddys car
Joined
·
1,447 Posts
Looks good man!

-Josh
 
1 - 6 of 6 Posts
Top