SR20 Forum banner

1 - 4 of 4 Posts
G

·
Guest
Joined
·
0 Posts
Discussion Starter #1
I want to polish the stock header cover...i need to take it out...but the o2 sensor wire is in the way...how do I disconnect the o2 wire from the o2 sensor itself...is it just a hard yank...what do i need to watch out for?

enlighten me since i dont want to screw up an expensive component like this...

Thanks...
 

·
Registered
Joined
·
3,793 Posts
a little harness connection and an o2 sensor wrench. go buy one. well worth the 3 dollars you spend on it

------------------
98 se-r w/ p/r cai,jwt s3 cams, stillen header, courtesy exhaust, ur pullies, JUN flywheel, ACT clutch, NOS nitrous kit, eibach springs, kyb struts, st sways, cusco camber plates, f/r strut braces,stillen lower control arm brace, lotsa bushings, and a bunch of other crap
 

·
Registered
Joined
·
466 Posts
Follow the wires up to the black oil seperator box. There is a gray plug. On the underside is a button, press the button and gently pull the connector apart. Pull on the connector and not the wires.
 
1 - 4 of 4 Posts
Top