SR20 Forum banner
1 - 8 of 8 Posts

· Registered
Joined
·
1,141 Posts
Discussion Starter · #1 ·
OK, I am having an annoying problem. My motor does not idle well. This happens the most when I drive for awhile. Then when I stop and apply the brakes, the idle drops, when I release them, the idle jumps back up. I also have started to notice that when I coast to a stop, the idle dips also. Does anyone have an idea of what could be causing this? Thanks for any help.

------------------
Kris94G20
87 Pulsar
 
G

·
i've got the same problem with my NX, but it didn't start until i took all the emmisions bullshit off, and if that is the only side affect, i don't really care.

------------------
1993 NX2000
with stuff.
 

· pwnd
Joined
·
4,155 Posts
is your G an auto? if so check your timing and idle. my timing was a little low and when eric set it back up to 15* it stoped all that trouble i had. also set your idle it helps too. mine is a little low now but nothing bad...i used to do what you said yours is doing when i was sitting with the brakes on.

------------------
Thats my opinion and I could be wrong

93 classic
Aztec Red, Automatic, POP, STB, OEC battery tie down, AD22VF's, Pirelli P4000's

 

· Registered
Joined
·
181 Posts
had the same problem set timing, checked gap on silverstone plugs and new cap and rotor.
my idol would dip so low it would stall when I stepped on the brakes..
 
1 - 8 of 8 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top