SR20 Forum banner
1 - 2 of 2 Posts

· Registered
320 Posts
Discussion Starter · #1 ·
Anyone done custom I/C piping and had your pipes bead rolled?

Im just wondering how much shops would charge for this.

· vincit omnia veritas
1,215 Posts
Just take the pipes to a shop and have them run a bead around the end of the pipe.
this is what I did, it is crude, effective, and no one can see it because it is under the connectors ;)

FWIW if anyone is having problems with IC piping hit me up with a private message and I will try and walk you through the process and give ya a few hints!
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.