[TREYDEE]

I need to know what should the 4 little switches in the back be set at??and also what is the balance dial for cause when I put it on sharp the boost drops???Thanks.

P.S. I am runnig a T25 on a 4bar JWT ecu with a 97 JDM high port motor.

 

[TREYDEE]

Will anyone help me out ?????

 

[mr.sentra_specv]

that last dial the balance one is for adjusting the spike issue but with the stock t25 its hard to get consitant boost above 10 psi. thats what i found out aleast.
mine would go from 11 psi down to 10 psi at bout 6000 rpm.
Rocco

 

[Big John]

Will anyone help me out ?????

John

EDIT: That was straight from GReddy.com

 

[TREYDEE]

Thanks Guys your the best!!!!!

 

[Nizmonik SE-R]

Wait so this means if he plans to boost over the 7psi the stock wastegate actuator is set at then he puts it on the lower setting? And if he plans to boost under the 7psi then he sets it to the higher one? B/c I have the same Boost Controller to be installed on my car and I've been wondering the same thing....

Allan

 

[mr.sentra_specv]

well you can only boost as low as the wastegate spring is set to. the boost controler lets you up the boost only.
Rocco

 

[Nizmonik SE-R]

well you can only boost as low as the wastegate spring is set to. the boost controler lets you up the boost only.
Rocco

Yea thats true, I totally forgot about that....Its been a very long day for me. But this still doesn't answer my question. WHICH ONE DO WE SET IT TO???

Alllan