SR20 Forum banner

1 - 1 of 1 Posts

·
A bit of everything
Joined
·
474 Posts
Discussion Starter #1
Sometimes when driving the car I will lose all response in the accelerator and then the car will not rev higher than 3k as if there is a limiter in place. I pull off the side of the road, mess with the wires coming out of the pigtail on the MAF and the car will go back to normal.

I have read that you can solder the wires back into the harness connector, but I don't see how that is possible since the harness connector doesn't open up or anything. I can get the wires to come out if I RIP them out, but then how would I get them to go back in?

This is an N60 MAF.
 
1 - 1 of 1 Posts
Top