[94_REDSE-R]

So I got my header and those DAMN catalytic bolts will not come off!!!!! arrrrgghh!!!
So I went ahead and hacksawed the damn thing off right before the resonator. Now heres the deal. I need to get a 15 inch extension from the header to the resonator.
1)-Can I just fabricate one or does a muffler shop have to do it?
2)-If I can fabricate one how do I make the ends bow out and fit the flanges?

ALL HELP IS HIGHLY APPRECIATED.
I will be attacking this project tomorrow morning.

 

[kris]

Use super glue and rubber bands

that should work.

------------------

Kris94G20™
"clears and stickers, the best bang for your buck"
The Beginning.

 

[94_REDSE-R]

<font face="Verdana, Arial" size="2">Originally posted by kbslacker:
Use super glue and rubber bands

that should work.

</font>

You dork!!

I tried that last time!!

 

[sr20]

how about duck tape?

 

[SERprise In WV]

94Red;

I did the same thing on my '93, as 149,000 miles are brutal on the cat bolts. I had to have mine towed to my exhaust shop, and the guy who owns it fabricated the piping and welded it.

Charged me $26.00, a bargain in my book.

------------------
Greg Perry, '93 SE-R w/ 149,000 miles, JWT pop, header, ProActive
clutch, ST bar, NOS direct-port 75hp, Autopower 4-point roll bar/harnesses.
[email protected] 1/4 mile, [email protected] 1/8 mile, 1.98 60-ft.

My SE-R page, with videos

 

[Stiletto]

i would think the best thing to do is let a professional at a muffler shop do the work. that is unless you own an arc welder.