SR20 Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
Hi everyone. I'm kind of new to Nissan and i am going to be getting a 94 se-r in a few days that threw a rod and i was just curious if the rods were the same in this engine as they are in the sr20det.

I have not been able to find any connecting rods for the de and i was thinking about getting forged h-beam det rods. this is why i am asking and i havent seen anything about them being interchangeable. thanks
 

·
Registered
Joined
·
1,311 Posts
I've never seen an aluminum blocked engine that survived a rod coming apart without a hole in the block.

Rods on older (non roller rocker) na sr20's are pretty stout. General consensus is they're good for 350 to 400 hp. I don't know if they're the same as turbo rods.
 

·
Registered
Joined
·
2 Posts
Discussion Starter · #3 ·
i kinda figured that too but i havent actually seen the car yet since the rod broke. if that is the case truly then i will probably just get a det to put in it but thanks for the help :)
 
1 - 3 of 3 Posts
Top