SR20 Forum banner
1 - 2 of 2 Posts

3,601 Posts
Discussion Starter · #1 ·
My Si friend has a digital camera and we just took some snaps of my car, mostly of the engine bay to show the battery shove I did.

Here's my first shot with the clearcorners installed:

full engine bay:

Here's a closeup of my Lightning Motorsports (really HP Racing) front strut tower brace. You can see the two little gray squares where the hood barely makes contact with it.

It only vibrates/makes noise when I go in reverse. Going to pickup the front/rear (in relation to the car) ES motor mount inserts to try and curb that problem.

Close up of the battery minimizing job I did:

And just a pic of from the driver's side of the engine bay:

[Edited by Ben98SentraSE (09-17-2000 at 11:25 AM).]
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.