SR20 Forum banner
1 - 6 of 6 Posts
G

·
Discussion Starter · #1 ·
Hey I have a question. How do I check to see if my O2 sensor is working properly? The dealer that I took it to ran a diagnostic on it and came up with no error codes. Is there a resistance test that I can perform on it ot see if its working properly? And also how do I test the TPS? I looked on the SE-R.net webpage but couldn't find any answers. thanks again for the help.

Brent
 

· Registered
Joined
·
6,556 Posts
no, no real way to test it out with a volt/ohm meter, but if you have more than 40k or so on it, go ahead and replace it. tps you can check it out with a voltmeter, and I believe it is the middle wire on it.

------------------
98 se-r w/ p/r cai,jwt s3 cams, stillen header, courtesy exhaust, ur pullies, JUN flywheel, ACT clutch, NOS nitrous kit, eibach springs, kyb struts, st sways, cusco camber plates, f/r strut braces,stillen lower control arm brace, lotsa bushings, and a bunch of other crap not really worth mentioning
 

· Registered
Joined
·
791 Posts
<font face="Verdana, Arial" size="2">Originally posted by Johnny GreenBack:
On this topic, anyone know how much a new O2 sensor runs?

</font>
you dont even wanna ask, trust me. its expensive thats all i know, really expensive.

------------------
Ryan Walsh...1st 97 owner ever to succesfully mount a 98SE exhaust to a 97SER!
relaxing after a quiet ride home from SF2K1. first day without an exhaust in a long time.
 
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top