SR20 Forum banner

1 - 7 of 7 Posts

·
Registered
Joined
·
287 Posts
Discussion Starter · #1 ·
I'm currently running a three gauge a-pillar w/ an Autometer oil pressure and water temp. gauge. I've been searching concerning what to use in the third spot but really haven't found any good suggestions. I was thinking of an EGT or A/F gauge but from what I've read they wouldn't be helpful. I'm currently N/A and am planning on upgrading to a JWT ECU soon so using the EGT gauge w/ an AFC really won't be necessary. Also, I cannot afford a expensive A/F gauge so I would pretty much be stuck w/ an Autometer gauge that makes pretty colors. I have also read of vacuum gauges to check for leaks but how useful is this?

Suggestions? Thanks.
 

·
Registered
Joined
·
287 Posts
Discussion Starter · #3 ·
I'd love to turbo it but if it happens it won't happen until the distant future. It's my daily car, it's not going to see a track often. My mods are in my sig. link.
 

·
www.FAIRTAX.org
Joined
·
8,920 Posts
Yes oil temp for sure.
 

·
Undecided
Joined
·
4,132 Posts
I say get oil temp if your car sees hard driving for periods longer than 10 minutes at a time. If not then I wouldn't worry about it. If your into stereos, get a Volt gauge. Like I said it all depends on what YOU do with the car.
 

·
Tired!
Joined
·
10,149 Posts
Volt meter or oil temp meter is what I would stick in there. Not all to concerned with A/F or EGT with an NA application.

Brent
 
1 - 7 of 7 Posts
Top