SR20 Forum banner

1 - 2 of 2 Posts

·
Not on fire... yet
Joined
·
591 Posts
Discussion Starter #1
These are the results of the mishap at Meridian (timing chain jumped).... The indentations are rather minor compared to some of the pics, Im mainly concerned about the sleeves in the cylinder wall......
Any opinions on if I can get by with smoothing out the damage or If I should send it off to a particular machine shop will be greatly appreciated.

http://albums.photopoint.com/j/AlbumIndex?u=1441425&a=11855729&f=

------------------
93 NX2K
some stuff and a DET
"project street mod?"
1988 BMW M3 w/ a few toys
 

·
Registered
Joined
·
466 Posts
I had hard to see from the pictures if the head was damaged. The valves are toast. I believe valves cost about $10 each. The pistons may be salvagable. If you are going to build the motor, get GTiR pistons. Or you can ship the motor to me and I'll see if it can be fixed. No guarentees that you will see it again though. It was nice to meet you this past weekend, and hopefully you can make it to the convention in May.

------------------
Eric Waterman
1996 200SX SE-R
1997 200SX SE-R
1991 Sentra SE-R
 
1 - 2 of 2 Posts
Top