SR20 Forum banner
1 - 1 of 1 Posts

2,463 Posts
Discussion Starter · #1 ·
I'm sure most of you remember my bitching about place racing's service. Anyway, I finally got my lower tube back. It does look very good after being sandblasted and re-powdercoated. I installed it Saturday morning.
Fit: Not bad. If only I could rebend the tubes slightly... I would cut the hole to the top right about 0.5" from the template (standing at the front bumper). But I didn't have to cut the lower tube at all as I've heard some people do. The air temp sensor fit fine.

Results: Wow! I've been running the warm-air setup for the past month. It was an improvement over stock, but not much. With the resonance effect, wow is all I can say. The cams and CAI really change this car.

other topic:
Ben, I paid $150 for the 2 pulley set from apex.
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.