SR20 Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
159 Posts
Discussion Starter · #1 ·
I have a wrecked se-r so I have all the parts I need flywheel, tranny mount tranny, ECU, Axles and all the shift linkage from a b13 se-r (1991-1994).

Will this stuff work to swap a auto g20 to a manual.

I need to know this as soon as possiable so I can snatch up a nice P10


My main consern is what won't work from my se-r
anything else different?

And Yes I posted this on the g20 forum board too. I know some people have worked a g20 tranny into there car and was wonder if they had to change anything for it to fit in there sentra.
 

·
Boost Addict
Joined
·
1,451 Posts
Everything seems like its goin to work. Not too sure about the crossmember though. But it's easy enough to check. The axles may be a problem because I think the g20 depending on the year will have a different hup spline. If that's the case you could just buy a set of manual axles for that year and use the SE-R's as the core. You'll also need the brake and clutch pedal from the sentra. I think that should do it.
 
1 - 2 of 2 Posts
Top