SR20 Forum banner
1 - 6 of 6 Posts

·
Registered
Joined
·
634 Posts
Discussion Starter · #1 ·
Hey guys,

I have a 91 and a 93 SER currently and will be doing pretty much a restore on my 93 from the suspension up. I sold some parts from it to purchase the 91 back in February. My question is that I sold the valve cover i had to another forum member and so at this moment the cams have surface rust on them as well as the Flywheel since I took most of the tranny out. Will the rust pose an issue at all and do i just sand them off or use some sort of chemical? Thanks guys.
 
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top