SR20 Forum banner
1 - 1 of 1 Posts

· Registered
6,556 Posts
Discussion Starter · #1 ·
ok, I am putting in my pullies, and am trying to think of a way to get off the crank pully. look down in there, and it is threaded. I try Najis screwdriver meathod with no luck, and finally I try a spashgaurd bolt, and it fits. that bolt is the same size as the ac line that goes along the shocktower on the passenger side, but the linebolt is about an inch long. anyway, pull those out, and they thread right in, and pully comes right off. just a fyi for you guys with no balancer puller or 23 inch bicepts.

98 se-r w/ p/r cai,jwt s3 cams, stillen header, courtesy exhaust, JUN flywheel, ACT clutch, NOS nitrous kit, eibach springs, kyb struts, st sways, cusco camber plates, f/r strut braces, lotsa bushings, and a bunch of other crap not really worth mentioning
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.