SR20 Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
476 Posts
Discussion Starter · #1 ·
Okay everytime i have installed my outlaw engineering spacers i have had to stop becuase of the throttle body. first i didnt have the right allen key to get it off, then when i tried the bolts were on to tight and i was flexing the allen key and stopped cause i was afraid the thing would bend or break. Any suggestions on getting it off? How did everyone else get thiers done? :confused:
 

·
Registered
Joined
·
4,498 Posts
Ever seen the socket sets that are allen keys? They're a very good tool to have.
 

·
No longer a member
Joined
·
6,093 Posts
it's a basic allen key, I don't recall the size, but it should be in everyone's tool box. I highly doubt it's too tight that you'll break the key, but yea, you can find allan key sockets that'll fit on a standard 3/8" ratchet, of look for a beefier looking allan key like the professionals use. They make big allan keys that have handles and so on.
 
1 - 4 of 4 Posts
Top