#1
·
Apr 29, 2007
i'm in the middle of aqcuiring my parts for my 5spd swap and i'm now to the stage where i need to choose a clutch kit
since i never drove much stick then i'm looking for a soft engaging ,durable-material heat resistant clutch for a low price
now, i've looked up xtd and all those similar companies, but i read some bad thing happenewd to theyre sprung clutch.
do they make unsprung clutch and would it be a good choices for somebody how never drove stick and his real low on the learning curve.
thanks yall mates
wounldnt make it without ya eh!
Joined Dec 10, 2006
·
510 Posts
for how much do these go for?
Joined Dec 10, 2006
·
510 Posts
i wanna go turbo later but thats not into consideration right now cause the clutch will probably destroyed by the time i go turbo
i have a stock de with no bolt ons other than a k&n filter on stock piping lol
plans are for bolt-on power with cams so i'd say about 160hp
i know sprung disks are soft engaging but i realy dont wanna risk a
http://www.sr20forum.com/showthread.php?t=178155&highlight=clutch+xtd
thats why ui wanna consider other alternative .
is there a un sprung clutch thats soft engaging?
Joined Dec 10, 2006
·
510 Posts
Just run a ACT HDSS and call it a day
not quite the argument i wa lookin fo
Joined Dec 10, 2006
·
510 Posts
i didnt say i want a 6 puck
i want a easy to handle clutch that can hold barely more than a stock de and last a long while, "friction material" wise
Joined Dec 10, 2006
·
510 Posts
is it easy to drive with?
i mean real easy cause last time i drove stick nothing in the world would ha ve stopped me from chokin the engine
Joined Dec 10, 2006
·
510 Posts
the guy in your pic make me thing of private pile in full metal jacket
on a side note
i should tell gregv to sell me a used clutch and flywheel setup?
he's stocking used stuff?
also i'm in canada and it'll cost aout 10 trillion buck if i call him
Joined Dec 10, 2006
·
510 Posts
sounds good to me
price range?
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.