SR20 Forum banner

Starter is done

674 Views 1 Reply 2 Participants Last post by  corbendallas
2
Well, 2 hours later, a couple cuts later, and its in. It was a bitch, there is this metal Y shaped plate in the back of the motor, covering the starter, that sucked trying to get get around. I ended up taking the intake piping off, removing the clutch cable bracket. But its all done, no more push starting.


Kris94G20
See less See more
1 - 2 of 2 Posts
I admire you.
I didn't even bother to try to replace my starter. After I found out what it took to replace one on my NX2000 I called the dealer (ugh)!! For towing and replacement, around 500$ bux. Ouch!
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top