SR20 Forum banner

Stripped crossmember

6K views 33 replies 23 participants last post by  rockyrodriguez 
#1 ·
I stripped the crossmember bolt hole in the front when I was putting it back on. I did my front and rear mounts today, also did the shifter bushings. Today was a bitch. Im never doing this again, haha. Anyway, I need to know what size tap to use for the bolt holes on the front of the cross member. TIA :tongue:
 
#29 ·
dont remember my x member is welded into place in the rear and is still going strong in the front.
 
#30 ·
ive only got 1 bolt holding mine, its always pretty easy to put on when your motor mounts are older but when you do the inserts you can really tell the difference.
 
#33 ·


^Got this from google. Is this what I need to get? Anything else? Can I get it from Advance?
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top