SR20 Forum banner
1 - 1 of 1 Posts

Premium Member
11,741 Posts
Discussion Starter · #1 ·
Well, I finally got them put in today, for the spring seats that i didnt have, i just used pieces of heater hosing wrapped around the coil.

Overall impressions:KYB GR2/Prokit combo is rather nice, i have already put about 200 miles, and it is definately an improvement over the Monroe/Arospeed combo. the previous spring/strut combo i had made the car a little lower, but it was more bouncy, it didnt bother me too much, but i thought it was time for something else. well, with the prokits, i have a little more wheelwell gap than before, but i wont complain about it.

Serban Gavrilescu
91 Black Metallic SE-R
146.5hp & 131.6lb-ft torque

Serban's SE-R Page
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.