SR20 Forum banner
1 - 1 of 2 Posts

· Registered
5 Posts
Discussion Starter · #1 ·
Question about timing. When timing the engine what should I be lining the needle up with on the pully? I have it set on the two dots that are closest together right now at 15 degrees like it says it should be at. Cuz there are other dots to the left and like one or two to the right of the two dots closest together. Cuz right now I notice the valves making noise when I let off the gas to shift. So that gets me thinkin about the timing and if i have it right?! Any light on the situation would be great! thanx!
1 - 1 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.