SR20 Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
521 Posts
Discussion Starter #1
I finished a the det swap over the weekend went out to drive it at it was freaking awsome, but it just started to rev in third gear so we pull it in the garage and it looks like on of the cv axles isn't seating all the way in (it was leaking) pull the tranny and it dosn't fit all the way in (I got this tranny when I got the engine jdm)the cv axle fits all the way in on the old tranny, but not on the new one it is the passenger side, is this because it is not limited slip or is or something and would this cause the tranny to act like the clutch is depressed the whole time
PLEASE HELP, thanks in advance, Jason

------------------
1991 NX2000 W/SR20DET SWAP,HKS INTAKE,3" EXHUAST,E.S. BUSHINGS AND MOUNTS.

NX 1600 INTAKE,AND EXHUAST
 
1 - 2 of 2 Posts
Top