SR20 Forum banner

1 - 8 of 8 Posts

·
pimpin since 03!
Joined
·
1,348 Posts
Discussion Starter · #1 ·
hey guys i am getting my ic piping today and will most likly have them welded tomorow soo... basicle i need to know where and what i route all my vacum hoses too.... on the cold side of the pipe. the WG, and the BOV... thanks guys pics would be nice too!

jake
 

·
pimpin since 03!
Joined
·
1,348 Posts
Discussion Starter · #2 ·
people keep saying to tap from my charcoal can with a t valve... well i seen another picture some where of an avenir.. and the bov seem to be ran by the hose that comes out from the middle of intake plenums 3-4 ... i dont know i think charlie needs to chime in !!! hes the only one that has the avenir that i know on this forum!!!

charlie need your help once again :confused:
 

·
pimpin since 03!
Joined
·
1,348 Posts
Discussion Starter · #3 ·
ohh and im not sure if the u12 motors have this? i know that my usdm sr20de did not come with this vacum hose
 

·
<>< Jesus is the Answer
Joined
·
5,518 Posts
I knew I saved this for a good reason.

This is from Charlie2020 a while back.

 

·
pimpin since 03!
Joined
·
1,348 Posts
Discussion Starter · #6 ·
good but its alittle small and i cant really read it.... maybe you can send me a bigger one email

[email protected]

thanks
 

·
<>< Jesus is the Answer
Joined
·
5,518 Posts
thats the size i saved it as...i tried enlarging it but it comes out as huge pixels....

print it then get strain to see it....thats what i had to do.
 

·
pimpin since 03!
Joined
·
1,348 Posts
Discussion Starter · #8 ·
thats cool man! it should help!
 
1 - 8 of 8 Posts
Top