SR20 Forum banner

1 - 7 of 7 Posts

·
natulog sa pansitan!
Joined
·
1,019 Posts
Discussion Starter #1 (Edited)
ive searched and searched didnt find the correct settings/configure how to make the VVL activate by using the TPS and rpm..

i already have my greddy mss working on my car by using only RPM and i have no problem with it whatsoever and now i wanted to use the TPS also together with RPM.

i read a lot of post of members that did the TPS but they didnt post how to configure it,so im lost:confused: :squint: .
and is the white and gray is the TPS wiring ryt?? white -tps signal and gray - good source of ground ????

need you guys help here:(
 

·
Registered
Joined
·
1,715 Posts
say if your wot is 4.02 set it to turn on say at like 4.00 and off at 3.98 . should be a setting for the voltage with a line _ thats lower so you would want to set the tps voltage to be off at 3.98 then the line -- thats when you turn it on at 4.00 . it takes time to understand but once you do you will sat wow why didnt i think of that before
 

·
natulog sa pansitan!
Joined
·
1,019 Posts
Discussion Starter #5
so i dont have to change my old settings that i followed from rockwood??

i just have to add or do the settings for vo_ and vo--???
 

·
Registered
Joined
·
1,715 Posts
yea just add them settings so it activates at wot at the rpm you have set and shuts off when off wot
 
1 - 7 of 7 Posts
Top