SR20 Forum banner

1 - 7 of 7 Posts

·
vincit omnia veritas
Joined
·
1,085 Posts
Discussion Starter · #1 ·
mid 270's (both hp and torque) to the wheels yield in a roughly 2150 pound car?
FWD, big slicks, if it was a *perfect* run?? (race gas, yada yada)?????
 

·
You like that, dontchya?
Joined
·
956 Posts
Hmm....seeing that I know of a JWT 100 shot B14 that ran low 12s with 240whp and had the launches down to an art, I'd say that 270whp and that light weight should get you a high 11.
 

·
vincit omnia veritas
Joined
·
1,085 Posts
Discussion Starter · #5 ·
Nollan, don't be a sarcastic bitch =)


and not bone stock, the turbo is stock, the motor is stock internals... USDM head.. race gas, lotsa tuning.. no nos for the bajillionth time...

The car was dyno'd... mid 270's to the wheels with both numbers.
The car is very, very stripped.
I have not heard the numbers on the weight, but I am sure it weighs more than 1800.. I I think 2150 is attainable with the amount it is stripped.. still, even if it was 2250...
 

·
Fmax Stg II B13
Joined
·
358 Posts
So if another car ran about the same time, trapped a few mph higher, ran small slicks with a 2.1 60ft (still spinning past the 60 in 2nd gear) and weighed in at a full stock weight of roughly 2500lbs, how much power would it make? And you had the nerve to tell me I was only putting out about 250whp at one time... go chew on that David ;)
 

·
vincit omnia veritas
Joined
·
1,085 Posts
Discussion Starter · #7 ·
BWA HAHAHA!

You know I was just screwin with ya...
You deserve it, and should deal with it.. mr fmax stage 2 :p

get it dyno'd and prove me wrong, motherbitch!
 
1 - 7 of 7 Posts
Top