SR20 Forum banner

1 - 4 of 4 Posts

·
s13 frankenstein
Joined
·
3,483 Posts
Discussion Starter · #1 · (Edited)
I ordered some delphi (msd) 50 lb injectors off ebay and when i recieved them, to my surprised, i ended up getting RC engineering 500 cc injectors (47.6 lb/hr). I am curious if i should try to get a refund or diff injectors of if these will be enough to handle a t3/t4 set up runnig 10~15 lbs. I was happy at first because tey are new and RC engineering injectors seem to be more expensive (atleast on ebay) so i figured i got more than i bargained for. Any thoughts?

EDIT:

I just reread the discription of the auction, they were labled 50lb/hr @ 43.5 psi, so i am guessing the 500 cc rating RC gave me might be at normal 3 bar?

EDIT AGAIN:

wait, nvm, 43.5 psi is 3 bar....
 

·
Registered
Joined
·
186 Posts
for t3/t4 i would get 72lb to be safe
 

·
Registered
Joined
·
695 Posts
50s are fine for his application... by the time U run out of injector with a T3/T4 U will be thrashing trannies left n right... Unless ur goal is like over 400WHP 50s are alright. I ran 740ccs in my GTi-R for my power goals :)
 
1 - 4 of 4 Posts
Top