SR20 Forum banner

1 - 17 of 17 Posts

·
Registered
Joined
·
31 Posts
Discussion Starter #1
i have a couple question about putting the ser harness onto the gitr engine

what is this part? and what does the 2 hoses connect too?

does this part connect to this clip
this is the part that is not on the harness that we dont know what it is

this is the conector on the harness

where does this MAF sensor plug into there is no spot on the gtir?
 

·
Registered
Joined
·
420 Posts
there are so many of those plugs that is not going to be used if using a se-r harness.
 

·
Registered
Joined
·
1,097 Posts
no idea what that is but the se-r harness is pretty simple to use on a gti-r just extend a few wires replace the side feed inj plugs with top feed swap out one plug for the aac valve ,swap the outer wires on the tps and your ready to go .
 

·
Registered
Joined
·
31 Posts
Discussion Starter #6
heres a couple better pictures







if any one knows what this is and where is goes and what it does please help
 

·
Registered
Joined
·
420 Posts
that piece isnt even on my gtir engine!!!
 

·
Registered
Joined
·
1,097 Posts
well I just finished my 2 gti-r in a b13 and I have never seen that part ever so dont sweat it just keep on plugging away
 

·
PWND by SR20's
Joined
·
646 Posts
That is a boost spike controller. It electronically controls boost spikes for the Pulsar GTI-R. There is unfortunately no plug in the USDM harness for it because of not being a turboed car to begin with. My GTI-R engine has one and I wish there was a way to use it :squint:
Anyway, it does not NEED to be used with your application so dont worry about it until you get a Pulsar :biggthump

Jeremy
 

·
PWND by SR20's
Joined
·
646 Posts
1 - 17 of 17 Posts
Top