SR20 Forum banner
1 - 20 of 36 Posts

· Registered
36 Posts
Discussion Starter · #1 · (Edited)
Fully built AWD Turbo Talon
Dynoed 513 AWHP!! at 22psi on 93 octane (wouldnt push it past that without race gas)!!

Buyer will get all receipts even the $16,000 engine build!!
PRICE: $8,000obo

I Just recently got the whole timing redone and paid for 6 sessions of tuning which i set at a very safe 418awhp and 356 torque...

170k on Body
10k on Motor & Trany (Evo 3 Block)

JDM 4g63 Block - Bored .20 over
Ross Race 8:5.1 Pistons
Eagle H-Beam Rods
Crower Cams & Cam Gears
Crower Titanium Valve Springs & Retainers
1mm SS Valves
Big Bore Lifters
ARP Engine Hardware & Headstuds
ACT Stage 5 Six Puck Clutch
ACT Flywheel
Precision Turbo Custom 60 Trim Turbine
Tial 40mm Wastegate
Tial Race BOV
Apexi Down Pipe
Apexi N1 Exhaust With HKS Carbon Titanium Muffler
720cc Injectors
AEM Fuel Rail
AEM Fuel Pressure Regulator
HKS Cosmo Fuel Pump
Apexi AVC-R Boost Controller
AEM EMS Engine Managment
Prothane Motor Mounts
JDM VR4 Valve Cover
Spearco Intercooler
HKS Head Gasket
JM Fab Intake Manifold
Slow Boy Racing Turbo Manifold
Coil-on-Plug Ignition

Full Race Built Tansmission
Aftermarket Limited Slip - 4 Spider Center

Eibach Springs
KYB 8-Way Ajustable Struts
Front & Rear Sway & Strut Bars

3000GT Dual Piston Calipers
Powerslot Rotors

Molded Body Kit
Evo 8 Black Paint Job
18" RacingHeart C5
Weapon R Racing Seats

THE BAD: valve seal


· Registered
40 Posts
i have a 92 240 with silvia front,sr20det motor,19" rims, body kit. some autometer gauges, dont know if u might be intrested i dont know how much u lookin to get but if i would sell my car i would want $7k.

856-466-9030 is my cell u can call me after 5pm if u are intrested.
1 - 20 of 36 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.